This tutorial shows step by step instructions on how to flash Stock ROM on Android Smartphone or Tablet using RockChip Batch Tool on Windows Computer.
Before proceeding to flash Stock Firmware on Android using RockChip Batch Tool, it is recommended to follow the below preparation steps for smoother flashing experience.
- Make a complete backup of your important data to a safe place as flashing ROM firmware will wipe all of your data.
- Make sure your Android phone or tablet is charged to at least 50-60% before flashing the firmware.
How to Flash Stock ROM using RockChip Batch Tool
Step 1: Download and install the RockChip Driver Assistant on your computer to install the required Android drivers. If you already have RockChip Drivers installed on your computer, then you can skip this step.
Step 2: Download and extract Android Stock ROM Firmware for your smartphone or tablet from here to your computer.
Step 3: Download and extract the RockChip Batch Tool on your computer. After extracting, you will find files, as shown in the image below.
Step 4: Now run RKBatchTool.exe to launch RockChip Batch Tool.
Step 5: Once the RockChip Batch Tool launches, click on the Browse button […] and select the firmware which you have extracted in Step #2.
Step 6: Once you have successfully selected the firmware, RockChip Batch Tool will verify and load the firmware.
Step 7: Now, power off your phone and press and hold the Volume Up button and connect it to the Computer using a USB cable.
Step 8: Do not release the Volume Up button until the icon 1 turns Green, as shown in the image below.
Step 9: Once the device is successfully connected, i.e., when the icon 1 turns green, click on the “Restore” button to begin the flashing process.
Step 10: Now, the firmware flashing process will start, and it usually takes 4-6 minutes to complete.
Step 11: Once the flashing process completes, you will see the “Restore Done Success” or “Upgrade Done Success” message.
Step 12: Now close the RockChip Batch Tool by clicking on the “Exit” button.
Step 13: Disconnect your phone or tablet from the computer and restart it.
Congratulations! Now you have successfully flashed Stock ROM using RockChip Batch Tool on Android Smartphone or Tablet.